2 wheel spacers 3 mm especially for use when the rim comes into contact with the enlarged brake system on the VW T6.1 or as seperation spacers for VW T5, 6, 6.1, Crafter 2017+

2 wheel spacers 3 mm especially for use when the rim comes into contact with the enlarged brake system on the VW T6.1 or as seperation spacers for VW T5, 6, 6.1, Crafter 2017+

These spacers are used to continue using all rims on the new generation VW T6.1, where there would be otherwise a contact with the slightly larger brake system. See image. This affects the front axle.
Examples of rims: Goss Triangular, ...

These spacers can also be used as a separating layer to use steel rims in combination with aluminum wheel spacers. (Positioning between steel wheel and aluminum wheel spacers)

• Material: stainless steel
• Disc thickness: 3mm per wheel (= 6mm per axle)
• Bolt circle(s)*: 120/5*
• Center hub hole: 65.1mm
• Can be used in conjunction with steel and aluminum rims.
• Sold as pair

Info concerning the brake issue: Attention: On vehicles T5,6, 6.1 with a large 17 inch brake system, 16 inch rims cannot be used as standard!

NOTE - Please note:

When using 3 mm wheel spacers, which are attached between the rim and the hub, the screw-in depth of the rim attachment is reduced by 2 turns.

It must be ensured that there is sufficient screw-in depth (M14x1.5 screws: at least 7.5 turns = 11 mm load-bearing thread). If necessary, new screws are to be used, which we can also supply.