TERRANGER Adaptation MAXTRAX pins to pair of airline lashing rails

TERRANGER Adaptation MAXTRAX pins to pair of airline lashing rails

The set is used to attach MAXTRAX recovery boards (recovery tracks) to two parallel airline lashing rails.

One set can be used to attach either two or four MAXTRAX Recovery Tracks.

Different variants are available to choose from

Contents:

4x stainless steel retaining plates

depending on the variant:
4x stainless steel slot nuts or 8x stainless steel lashing rail nuts 2.0
8x M8x10 A2 - 70 screws
Optional 4x Maxtrax fastening pins, made of black nylon and stainless steel

Each fastening pin can be released quickly and without tools and has an opening for a padlock (not included).

The distance between the two airline lashing rails can be as follows:

200 mm
270 mm
340 mm
820 mm
890 mm
960 mm
The sliding blocks for screwing on the pins must be inserted at the end of an airline lashing rail (open on the outside). If this is not possible, you must select the variant with lashing rail nut for insertion (-Pin-fix).